![]() I will keep everyone posted on my progress. I have a sub harness on order so I can get firsthand knowledge of the connectors.įrom what I could see on the schematic and looking at the photos on ECs site, there is one connector for each saddle bag for the turn signals and one under the seat for tail and brake. Star Venture & Star Eluder 2018 + 364.95. Most hitches quite often fit just one bike. Much will depend on the availability of the connectors as to whether I can build a complete system or will I need to order their sub harness and add the isolation system. HITCHDOC designers study each motorcycle model individually to create a trailer hitch that fits that specific motorcycle. A few days later I found the schematics here on the forum and confirmed that yes three different locations needed to be tapped into. When I looked at Buckfan's bike it became very obvious that there was no one master joint for the fender harness like on the Royal Stars, Ventures and other Star bikes from Yamaha and with out having a wiring schematic at the time we were just shooting in the dark disconnecting plugs to see what did not work. There is apparently not a single location to tie in the connector as some of the lights are on the saddlebags. I don't remember but something like an 8 pin, a 5 pin, and a 4 pin. I haven't seen it yet but they told me over the phone that there are three connectors connecting it to the bike. The bike is motivated by a new air-and-oil-cooled engine. If you can do it better and/or cheaper, then you should go for it. The new Star Venture (24,999) is built upon a hybrid frame (steel main section with an aluminum subframe). Mine came to about $126.00 plus a couple bucks for shipping. Hitch is hidden with tongue removed Chrome plated tongue is removed in seconds by pulling a pin & sliding it out Bolt-on installation made easy with. Mine wasn't terrible because I didn't need the third component, the 5 to 4 adapter because the lights on my Bushtec match up without it. I presented a sample of my Royal Star subharmess to Bushtec at one of the rallies in Daytona, hoping to get some sales, but they turned the unit over to EC and about a month later EC was offering the same subharness on their site. I may just reverse engineer the subharness, that is what EC did to me years ago. I am sure I could even buy the subharness from EC and add the Isolator (4 or 5 wire) and sell it for less than what they are selling a complete system for and it would be easier to install. Buckfann was kind enough to let me poke around his bike a month or so ago looking for the connectors needed, but we just did not dig deep enough. I think my friend Dion was referring to me in his post, and I am already thinking about it.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |